Xiware designs, engineers and manufactures die-cast metal headlamps end to end, then builds them under your label. Choose a housing from our mould library, set the performance tier, and go to market without paying for a tool.
The difference is who owns the design and who pays for the tool. That decides your cost, your lead time — and how much of the product you actually control.
You own the design and the tool. We cut the mould, run samples and build to your files. It works — but the NRE, the tool build and the DFM rounds all sit on your side of the table, and the first saleable unit is months away.
The housing already exists as a mould in our library. You pick the model, decide the performance tier, colour and packaging, and sell it as your own. The engineering and the tool were paid for once, across the range.
A trader buys a container and prints a logo on the carton. No visibility of the tool, the LED bin or the test data — and nobody to call when a batch goes wrong. Cheap until the first quality claim arrives.
Three headlamp platforms in production today, each with a datasheet rather than a paragraph of adjectives. These are the numbers the parts actually measure.
The lightest metal body in the line: the same thermal duty as the larger heads, carried in roughly a third less mass on the band.
The compact, everyday member of the line: the same die-cast metal construction as the M3, in a smaller, lighter body aimed at daily carry.
The high-output platform the factory was built around: a metal head that carries the heat, with the cell moved to a rear pack so the mass sits where a head can carry it.
A mould is a start, not a product. We design the whole light and manage the build — casting and machining through qualified partners, plus driver, optics, assembly and measurement in our own production. One accountable partner instead of a chain of suppliers, which is why a colour change is a phone call rather than a re-qualification.
Tool design and mould specification for aluminium and magnesium, with casting run by qualified partner foundries to our tooling, tolerances and quality plan. The library moulds are ours.
Mating faces, threads and sealing grooves cut after casting, then anodised or painted to your colourway — two-tone bodies included. Run through vetted machining and finishing partners to our drawings.
Constant-current drivers, mode logic, charging and protection built around the cell and the LED we actually fit, not a bought-in module.
Reflector and TIR selection matched to the housing, with the heat path decided while the casting is still on screen.
Documented work instructions at every bench, in-process checks, and batch records that follow the goods out of the door.
An integrating sphere on site. Every lumen, runtime and beam figure we publish is measured here — not copied from an LED datasheet.
Aluminium and magnesium die-casting, machining and CMM inspection in qualified partner shops; our own assembly benches and photometric lab. Photographed as they run, not staged for a brochure.
Casting, machining and dimensional inspection run through qualified partners we specify and audit. Assembly, branding and photometric measurement run on our floor in Dongguan. One team stays accountable for the whole chain.
Five steps, one accountable contact, and no tool to pay for on the way through.
Pick a housing from the library and the performance tier you want to sell. The datasheet, the option matrix and photographs of the actual moulded part follow within two working days.
LED bin, driver output, battery, optic, finish and control layout fixed in writing. Everything on the option matrix can move; the housing geometry cannot.
Pre-production units built on the production tooling, laser-marked with your logo, measured on the sphere and shipped with the test report attached.
Golden sample approved by both sides. Label, manual and packaging files frozen, then the batch is scheduled backwards from your launch date.
Batch production with output tested on every unit, retail-ready packing and shipping documents under your name. Reorders run on the same mould and the same test record.
Lead times are quoted per order and depend on finish, packaging and season. The sample route is the one that decides the schedule — not the enquiry date.
Not chosen yet? Send the price band and the shelf you are aiming at, and we will point at the two models that fit.
